5
Futaba and Multiplex connection
Futaba and Multiplex systems do not offer wireless device configuration. The telemetry transmission is possible with
the following fixed sensor slots:
Futaba S.Bus2
Multiplex MSB
Current 1
2
3
Voltage 1
3
2
Capacity 1
4
4
Current 2
5
6
Voltage 2
6
5
Capacity 2
7
7
Note
Manual detection in the menu Linkage – Sensor. Choose
S1678 current sensor on slot
2 and 5
.
Automatically detected by the transmitter.
S
AFETY INFORMATION
Operate the Voltario T60 always in dry environment and within the device limits stated in this guide. Never
expose the device to excessive heat or cold.
Do not remove the heat shrink tube from the device and do not try to implement any changes or
modifications. This can lead to a total destruction and to the denial of any warranty claims.
Always check the polarity of the cables. Never inverse the polarity – this could lead to total destruction.
Always use a sufficient power source according to the consumption of the attached servos. Never exceed the
maximum allowed operating voltage of the attached servos.
F
IRMWARE
U
PDATE
Firmware updates for the Voltario T60 are transferred from a PC via the USB interface. The required programs and
Install the MAV Manager software and the USB drivers on your computer. Check the system requirements.
1)
Disconnect all devices attached to the Voltario T60.
2)
Connect the USB interface to your PC, run MAV Manager and select the correct COM Port.
3)
Connect the T60 according to the picture below.
4)
Apply external power to the T60 via B1 or B2 battery inputs.
5)
Select the appropriate *.BIN file and press the Update button.
W
ARRANTY
We grant a warranty of 24 months from the day of purchase under the assumption that they have been operated in
conformity with these instructions at recommended voltages and that they were not damaged mechanically.
Warranty and post warranty service is provided by the manufacturer.
