3
T
OUCH SWITCH
Installation inside the fuselage.
Installation on top of the fuselage.
Touch switch behavior
Place the touch button anywhere on your model on the surface made of nonconductive material. You can
place the touch button also inside the fuselage with maximum thickness up to 3mm.
Make the status LED visible from outside the fuselage and put the “touch” sticker on top of the touch surface.
Connect the receiver battery to the Voltario and briefly touch the button. Status LED should blink once. If not,
please increase the touch sensitivity parameter in the configuration.
Touch and hold the button for about 2 seconds. After the initial blink, the LED will start blinking again. At this
moment, release the button. The main output will be activated:
T
ELEMETRY AND
S
ETTINGS
The device is compatible with JETIBOX/SMART-BOX and you can use it for programming. The JETIBOX menu is
divided into three sections:
Actual values
– displays the latest telemetry values (current, voltage, capacity, temperature) together with
minimums and maximums.
o
The main screen shows device temperature together with voltage and current of the active battery. If
the charging is enabled and active, the „CHG“ status is displayed.
o
In the Capacity screen, you can press left+right buttons together to reset the measured capacity. The
asterisk marks the active battery input.
o
The “Time” screen shows a cumulative time of the primary and secondary battery input, meaning how
long each source has been used to power the device.
o
Reset Min/Max - press left+right buttons together to reset all minimums and maximums.
