Elite Learning Universal Remote Control
– R800D
Ver. 1.1
www.elitescreens.com
/
/ Page 20 of 23
Press and hold the
ALL OFF
key about 2~3 seconds and then release them. The remote control will send out all
current power signal to turn on(or turn off) for every device one by one. Meanwhile the device key flashes to tell you
which power signal is been sending.
Remark: The remote control must be pointed to device that you like to control until the operation finished.
☆
11:Macro Function
Macro function let you make sequent operation for you home theater. Press and hold the
MACRO
key and digital
nember
1
key
( or 2,3 key), and then release them. The device LED will flash and the remote control will send out a
sequent IR commands that you programmed before.
You can set up a Macro by following below steps:
1. Press and hold the
SET
key for more than 3 seconds, then release it.
2. Press the
or
key to select
MA C R O
in the LCD menu, and then press the
OK
key.
3. Press the
or
key to select the
M A C R O 1
in the LCD menu (or
Macro2
or
Macro3
), then press the
OK
key.
4. The screen shows
S E T U P
, and then press the
OK
key.
5. You can select the device and function key for a sequent operation that you like. (e.g.:
TV+POWER+MUTE+AV,
DVD+PLAY, VCR+RECORD
,
etc. That means you want turn on the TV and shut off it’s sound, switch TV input to AV
port, at the same time DVD start to play disc, VCR begins to record
)
6. Press the
OK
key to save the setting, LCD shows
SUCCESS
then exit to current setup state,
7. You can press any device key to finish set up or press the
EXIT
key to last state and use
or
to select
other set up.
