Elite Novo, Instructions Manual

Page: 13 / 40

13
EN
Thank you for choosing the Novo
01_GENERAL SAFETY WARNINGS
Before using your trainer, carefully read
the warnings listed below for your health
and safety.
1. The appliance is not to be used by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction.
2. Children being supervised not to play
with the appliance.
3. Before beginning a training programme,
undergo a physical examination certifying
good health.
4. Choose a training level compatible with
your physical endurance and the status of
your health.
5. If you feel particularly fatigued or sore
while exercising, stop using the trainer
immediately and consult your doctor.
The above warnings are general and not
exhaustive of all the precautions that
should be taken for the proper and safe
use of the trainer; which is solely the
responsibility of the user.
02_PRODUCT MODIFICATIONS
Also in view of any technical update, ELITE reserves
the right to make changes to the products or their
specifications without being obliged to notify or inform the
Customer beforehand for:
a) changes that do not affect negatively the product
performance;
b) changes required to meet or improve the product
specifications;
c) changes necessary for the products to comply with the
applicable legal requirements.
ELITE also reserves the right to supply these products with
these improvements without being obliged to or responsible
for applying the same modifications to any previously
purchased products, reserving also the right to change
prices and model availability according to market
conditions, component availability and other corporate
considerations.
03_INTRODUCTION
Check the presence of all the following components:
N°1 Novo frame
(Ref. A)
N°1 Unit (Ref. B)
N°1 Unit support (Ref. C)
N°1 Quick release (Ref. D)
N°2 Plugs for wheels larger than 28” (Ref. E)
N°1 Screw (Ref. F)
N°2 Washer (Ref G)
N°1 Nut (Ref H)
N°1 Fixing lever (Ref I)
ATTENTION
Resistance unit depicted here may vary from production
models
04_STAND ASSEMBLY
• Open the stand and position it on a flat surface.
• Remove the screws (F+G+H) on the stand (Fig.1).
• Take the unit support (C), press the two buttons on the
upper part of the support (Fig. 2) with fingers, and fit it
inside the two holes in the frame (Fig.3 and Fig.4)
• Using the screw shown in Fig.1 (F+G+H), fit the unit
support (C) on the respective frame (Fig.5). Use the
correct tightening force, otherwise the unit support will be
prevented from turning.
05_UNIT INSTALLATION
• There are two pairs of holes in the base of the support;
use the various holes according to the bicycle wheel:
1) for wheels ≥ 24” ÷ ≤ 26”, front pair of holes (Fig. 6);
2) for wheels ≥ 28”, rear pair of holes (Fig.7).
• Depending on the wheel, tighten the M6 screws (Fig. 8
and Fig. 9).
• For bicycles with wheels larger than 28” it is necessary
to operates on the frame, changing the plugs of the front
uprights with the oversize plugs provided (E). These differ
for the stand opening angle.
ATTENTION: This operation must be carried out with the
unit removed from the support.
• Remove the screws from both front uprights (Fig.10 and
Fig.11).
• Remove the plug, using a screwdriver if necessary Fig.
12.
• Insert it inside the seat specially created in the plug and
prise, pushing the screwdriver downward and the plug