Rev101612-JA
www.elitescreens.com/ide2
3
Installation using double-sided tape
For models IWB86VW2, IWB97XW2, and IWB105HW2
1.
Begin by marking the size of the screen size to be installed on the wall or surface.
2.
Peel off one side of the double-sided adhesive film
tape and apply it from top to bottom (vertically)
every four to six inches apart from one end to the
other.
3.
After the double-sided tape has been applied, completely peel off the first strip and peel off the
rest about an inch as shown below.
Two people required
:
4.
Carefully pick up the Insta-DE2 film and make sure the back side is facing the wall it will be
installed on. Do not allow the film to fold in any way to avoid permanent damage.
Note: The back side of the Insta-DE2 is shinny.
5.
Gently bring the Insta-DE2’s edge as close as possible to the
installation area, align it, and gently press on the Insta-DE 2
with your fingers in a up and down sliding motion to finish
attaching the first end. Continue to completely remove the
remaining tape strips and repeat procedure on strip at a time
to ensure no air bubbles/pockets are created.
6.
Repeat the process throughout the rest of the material and
use the smoothing tool in an upward and downward motion
to assure a flat installation and to remove any air
bubbles/pockets that could arise.
Caution:
The adhesive surface of the double-sided tape is meant to be permanent for the life of the product. It
does not remove easily. Please attach very carefully to avoid having to remove the product and
positioning it in a different location.
Tape strip completely removed
