Rev.041717-DR
www.elitescreens.com
11
NOTE: Make sure the bottom edge trim with the Elite Screens logo is installed on the correct side. The back of
the material should be labeled with a DOWN sticker to indicate the material is facing in the down position. The
Elite Screens logo should be installed on the DOWN side
3.
After properly aligning all trim pieces, carefully remove trim piece
A
(see Figure 3 below). Remove the inside
backing of the tape and place the trim piece in its original position on the frame. Repeat this step for the
remaining trim pieces in the following order:
B-C-D-E-F.
4.
After the bezel trim has been installed, place a
corner sleeve
(K)
on all four corners. Begin by aligning and
adjusting the corner sleeve through the front of the screen. Make sure the corner sleeve completely wraps the
edge of the bezel trim. This should cover any corner gaps.
Once all corner sleeves have been snapped into each corner of the frame, it is ready to be installed.
Trim
strip
Front Side
Back Side
Front side
Back side
TIP:
Align the trim starting
from the center to reduce
gapping. Any gaps left at
the corners will be
covered by the corner
sleeves.
The
front side
of the frame with trim pieces attached.
A
B
F
C
D
E
Corner gap
will be
covered by
the
corner
sleeve (K).
Figure 3
Figure 2
White area
signifies
corner gap.
White area
signifies
corner gap.