Rev.032722DT (DS0189)
6
Spring Attachment Method
First hook one end of the spring in the frame slot, then hold the screen around the frame to pull, and finally use the
spring hook to pull the spring hook in the screen hole.
1.
Connect
Edge Trims A&B to
form the top/bottom trims with the
⑧
Short Center joints
, and then
insert them on the top/bottom frames.
2. Connect the
side edge trims
C
with the top/bottom edge trim with
⑮
Elbow Joints C
.
3. Adjust the trim so that the top and bottom trim pieces are touching and show no gaps on the corners.
Then fasten them with the
⑨
M4 x 4 screws.
1
. Carefully and gently place the assembled frame on
top of the screen material.
DO NOT
allow the angle edge of the frame to come in
direct contact with the material to avoid puncturing it.
2.
Adjust the distance between the edge of the frame and
the material (a1 = a2) to 1.4”/35 mm
Backside of screen
a1=a2
a2
Backside of screen
a1
3. Begin by simultaneously attaching three springs in
the center of the side frames (C→D) and repeat for
top/bottom frames (A→B).
4. Then, simultaneously attach the springs from the
center to all corners. (Leaving only the four corners.
5. Finally, attach the springs at the four corners
(E→F→G→H).
Backside of screen
5.
Bezel Trim Frame Assembly/Installation
Center
connection
⑧
Short Center
Joints
⑮
Elbow Joints
C
Corner
connection
