Rev.032722DT (DS0189)
5
3.
Re-attach black backing cloth from center to corner and pull the black backing cloth to fit the velcro to make
it more compact again. Then finish to attaching the black backing to the velcro.
Unrolling the screen material
Two people recommended
1. Put on the supplied pair of white gloves.
This is to avoid leaving oily handprints on the
screen surface which are not removable.
2.
Remove the screen material from the tube and
place a small suitable weighted object at the end
of the material.
3. Lay the material face down, two people
carefully lift the rolled end and slowly rotate the
material clockwise.
4.
Insert the corresponding fiberglass rods through the sleeves on the edges of the material as shown below.
Back side of screen material
Weighted
object
Back side of screen
Note: Backside facing up
(frontside facing down)
Front side of screen
Clean surface area
ATTENTION: Put the gloves on when handling the screen material to avoid touching it with your bare hands.
4. Screen
Material Installation
Fiberglass rod
a1 = a2
≒
35mm
Backside of screen
22
