If you experience a problem with your projector, please refer to the following
information. If a problem persists, please contact your local retailer or service
center.
No image appears on screen
Image is out of focus
Make sure the projection distance is in valid range (refer to page 10).
Ensure the cable is fine.
Image is too small or too large
No sound
Supported HDMI input video signal:
s
on the remote control .
* If an invalid signal is input into the projector, it will not be displayed properly on the screen or a
message such as 'not support' will be displayed.
* To provide the best picture quality, 1920 x 1080 (1080p) resolution is recommended.
Item
Description
Imager
DLP
Native
Resolution
1
x 1080
Projection
Distance
0.
-0.
m (1' " - 2'2") (from screen to lens)
Projection
Focus
Manual
Throw Ratio
0. (80"@0.5m)
Keystone
Vertical keystone
Projection Modes
Front Table, Rear Table, Front Ceiling, Rear
Ceiling
Standard Input
Up to
(1920 x 1080)
SDTV/EDTV/
HDTV
480i, 480p, 576i, 576p, 720p, 1080p
Horizontal
Frequency
30.5 - 91.1kHz
Vertical
Frequency
50 - 85Hz
Operating
Temperature
0 - 40°C
Dimensions
(WxHxD)
(back) / 127(front) mm
AC adapter
Power Input
100 - 240V, 50 - 60Hz
19V DC, 6.3A
Power
Consumption
Lamp
RGB LED
Lamp Life
20,000 Hours
Speakers
8W x 2 music power
Battery Capacity
37200mAH (135 Watt-Hours)
(only for MGFU-S model)
Input/Output
Ports
Alt-DP (USB type C connector) x 1
HDMI 1.4 x 2
Resolution
640 x 350
720 x 400
640 x 480
800 x 600
1024 x 768
1152 x 864
1360 x 768
1280 x 1024
1920 x 1080
Horizontal Frequency (kHz)
Vertical Frequency (Hz)
31.468
31.469
31.469
37.879
48.363
54.348
47.712
63.981
67.5
70.09
70.08
59.94
60.31
60.00
60.053
60.015
60.020
60
Earphone out
USB type A poewr charging port (5V1A) x 2
12V Trigger Out (0.1A output max.)
Wireless Speaker audio in x 1
Security
Kensington Slot
Waterproof
IPX2
1.52-2.54 m (
" - 100")
Less than 120W
USB type C PD power source port x 2 (Note)
63(&,),&$7,216
7528%/(6+227,1*
Lens with dust or water drops
• Projecting test pattern (“Menu” -> “Picture” ,press ”OK”-> “Pattern Test”
,press ”OK”)
• Adjust the focus ring, make the line pattern on four corners and center
clear.Exit “Pattern”by press “OK”again.
• Use a hairdryer on a low heat setting to clear away dust, water or other
particles. To Prevent Damaging the Surface Coating, DO-NOT Touch,
Wipe or Clean the Lens.If the projection surface is heavily soiled, contact
the manufacturer for further assistance.
Size
*Note:
Power Delivery (PD): maximum 5V/3A,9V/3A,15V/3A,20V/4.35A for port USB type-C port
maximum 5V/3A,9V/3A,15V/2A,20V/1.5A for port USB type-C port
3
8
*Note:
MGFU-S/MGFU-L is splash resistant and was tested under controlled laboratory
conditions with a rating of IPX2 under IEC standard 60529. Splash resistance are
not permanent conditions and resistance might decrease as a result of normal wear.
Do not attempt to charge a wet MGFU-S/MGFU-L; Liquid damage not covered
under warranty. “To Prevent Damaging the Surface Coating, DO-NOT Touch, Wipe
or Clean the Lens.*Consult the manufacturer for special cleaning instructions.”
*Note:
When the projector’s temperature is too high, the projector automatically shuts down
due to the built-in temperature protection. This is not a malfunction. Let the projector
cool down before switching it on again.
for more update user manual:
Electronic file link
www.eliteprojector.com/MGFU/manual
www.eliteprojector.com
P r i n t e d i n T a i w a n
FBZZ-MG1Z002-03
