Elite Models aviator pro 120, Instruction Manual

Page: 12 / 24

www.valuehobby.com/aviator-120-arf.html
12
Section4. Tail Set Installation
Step1. Remove the covering on the horizontal
stabilizer and fuselage.
Step2. Put the stabilizer and fin into the fuselage,
with the leading edge pushed against the fuselage.
Center the stabilizer by measuring the distance
from the fuselage to each tip. The stabilizer is
aligned when both measurements are identical.
Step3. Check the distance from each stabilizer tip
to each wing tip. These measurements must also
be equal.
Step4. The last alignment step is making sure the
wing and stabilizer are parallel.
Step5. Make sure the fin is perpendicular with the
stabilizer.
Step6. Use a pen to trace the outline of the
fuselage and fin on the bottom and top of the
stabilizer.
Use a pen to trace the outline of the fuselage and
stabilizer on the both sides of the fin.
Step7. Remove the covering on the stabilizer along
the line marked in the previous steps.