11
ADD GLASS DOORS
Insert 4 Plastic
Bushings (S)
into holes in
Bottom Panel
(1) and under-
side of Top
Panel (2).
Insert 2 Glass
Door Hinges
(N) into
Bushings (S)
of Bottom
Panel (1) as
indicated.
Add 2 Glass
Door Hinges (N) to
Glass Doors (8)
slipping Protective
Plates (P) between
glass and hinge
setting screws.
Insert Glass Door into Bushing in Top Panel and
slide into hinge at bottom. Tighten set screws at
top and bottom.
NOTE: If doors overlap, loosen setting screws and slide
door in hinge as needed. Make sure setting screws stay
in contact with protective plates when tightened,
Remove paper backing from Foam Pad (R) and
attach/wrap over top inner corner of door. Slide metal
Strike Plate (Q) over pad.
Repeat for second door.
S
S
S
S
N
P
R
Q
IMPORTANT NOTICE
Top Panel, Part #2
is designed to be used with TV's and other A/V equipment NOT weighing more than 176 lbs.
The loading weight needs to be evenly distributed across top panel and for optimum stability,
Place TV in a center position on Top Panel, not unbalanced to the side against edge for example.
If the TV’s supporting legs on the left & right are naturally situated directly above location of supporting
Side Panels (3),
you may then load up to 198 lbs. maximum on Top Panel (2).
Also: Note dimensions for Top Panel Surface as listed at the beginning of this manual and
read the following "Important Safety Precautions".
Bottom Panel, Part #1
is divided into two separate compartments. Each side is designed to be used with A/V
components NOT weighing more than 55 lbs. per compartment.
Adjustable Shelves, Part #6,
are designed to be used with A/V components
NOT weighing more than 22 lbs. per shelf.
HOWEVER, for the total unit loading capacity, DO NOT exceed a total of 290 lbs.
IMPORTANT SAFETY PRECAUTIONS
Please carefully read & follow these
important safety information notes
for proper use of the furniture you have just assembled. They are
designed to avoid unsafe conditions
that can
result in property damage, bodily injury or death. We therefore urge strict adherence to the following basic principals:
• Install this unit on a flat & level surface only.
• Avoid placing unit in direct sunlight or near heating source. We recommend not placing unit directly against wall but rather leaving a narrow space between unit and wall for proper
ventilation of your A/V equipment.
• Do not exceed the above recommended weight loading limits as this can result in sagging or structural failure of the supporting panel leading to unsafe conditions.
• TV screen sizes are measured diagonally, therefore, base foot-print size for specific TV’s can not be determined by screen size as they vary from manufacturer to manufacturer. Rather
you will need to measure the TV’s base foot print and compare it to the top panel surface size of your furniture as listed in this manual.
• Make sure to place TV
within
the surface area of the top panel, a bit inward from the front edge and centered.
Never
use with a TV that is
too large. The TV base foot print surface
must be able to sit completely on the top panel surface.
• When choosing locations for stacking A/V components on shelves, make sure to place the heaviest A/V equipment on the lowest possible shelves/bottom panels first.
•
Children should
never be allowed to climb on or play with this furniture or/and the TV.
This can result in an unsafe situation which may lead to the TV and/or the furniture itself to
become unsteady, slip, tip or fall over. Avoid using higher shelves or the top surface of the TV for objects that may tempt children to reach and climb. Such items can include toys,
food, as well as remote controls, etc. Proper supervision and common sense is always required.
• Glass doors are “Tempered.” This is a special process for achieving strength and safety. Although durable & solid we recommend avoiding bumping into glass with force or dropping
or chipping edges etc. Special caution should be given to glass corners, both, for protection of glass as well as most importantly to avoid the possibility of injuries resulting from
strong impacts against corners especially with children. Doors should be opened & closed gently. (Tempered glass is designed to shatter upon very strong impact and rather than
producing sharp knife-like dangerous edges, it turns instead into small pebble-like pieces.)
•
Moving the unit:
The strong caster wheels on this unit are intended for normal short-distance indoor use only, not for rough floor surfaces or outdoor use. Do not drag unit
when moving and especially be careful not to move unit on a carpeted surface or on a rug if it may pose resistance for caster mobility. If conditions are such, it is always
recommended instead to lift unit from both ends with a friend’s help. For the sake of safety and to avoid damages, we recomend you move the TV and all A/V components
prior to moving this unit. If this is not possible please use much caution and good judgement and seek help to ensure stability and safety as the unit is being moved. Make
sure afterwards to properly re-adjust all equipment, centered and stable as originally instructed above.
Congratulations and enjoy your new ELITE product!
To clean your unit, apply window cleaner with soft tissue. This will also eliminate slight surface abrasions
or scratches that may have occurred in shipping or handling.
Distributed by: Elite Industries, 77 Gould Street • Bayonne, NJ 07002, Tel.: 201-436-1120 • Fax: 201-436-6960
Elite Industries ensures complete satisfaction with this product. In the event of missing or damaged parts call toll free,
Customer service hours: 8:45-4:30, Monday-Friday, EST., 1-800-ELITE-48 • VISIT OUR WEBSITE AT: www.elite-inds.com
N
N
477445
Page 4/4
08.30.10