8
a. Set the rotary switch at desired range.
b. Press the trigger to open the jaw and fully enclose only one wire. No air
gap is allowed between the two half jaws.
c. Read the measured value from the LCD display.
C.AC/DC Voltage Measurements
a.Set the rotary switch at 400V
b.Insert the test leads into the input jack.
c.Connect the test prods of the test leads in PARALLEL to the circuit
to be measured.
d.prees Mode button to selet ACV or DCV function.
e.Read the measured value from the LCD display.
WARNING:
Maximum input for DC V is
6
00,and for AC V is
60
0. Do
not attempt to take any voltage measurement that exceeds the limits.
Exceeding the limits could cause electrical shock and damage to the
clamp meter.