Installation Guide
1. Turn off your vehicle engine.
2. Insert the TF card into the recorder slot.
[Note] Please use the high-speed TF card (Class10 above),
capacity of not less than 8G. TF card can support up to 32GB.
3. The recorder is fixed to the rearview mirror of the car.
4. Insert the car charger into the car cigarette lighter.
5. Extension cable charging the recorder's USB connector and car
charger is connected.
[Note] Reduces charging extension cord wiring can be laid along the
edge of the windshield.
6. The rear camera is installed in the rear of the vehicle. Pay
attention to the direction of installation. Wiring can be laid along the
vehicle roof. After the installation is complete you will plug into the
recorder rear camera interface.
7. Adjust the lens position to ensure that the lens levels with the
ground.
8. Start the engine and check if the machine has been installed
correctly.
9. For Best Result in using Dash Camera, we definitely recommend
to keep it plug-in into the car cigarette charger. This will allow you to
use or record for a longer period of time. Dash Camera uses a lot of
battery due to G Sensor system of the camera.
10. To watch recorded video clips, please remove SD card from Dash
Camera and connect it to your computer or laptop. This will allow you
to watch all videos recorded.
11. Please peel off the protective film on the screen before use.
[Note] When the machine is properly installed, the system indicator lights
will work; the machine starts to enter the recording state and the
recording indicator light flashes. Remember to check if the display screen
is normal.
