www.elinz.com.au
1300 881 773
• Dash cam is not recording properly, please check:
1. Format the sd card and try again.
2. Change to another sd card and try again.
3. Reset to factory settings under menu.
Under normal operating conditions, please refer to the solutions.
Unable to boot:
Check the recorder and car charger if properly connected, if you manually turned on, check the battery level if it is too low needs recharging.
Press RESET button to restore to factory settings.
When the camera automatically stops recording, or do not cycle the camera:
Due to the huge high-definition video data, it is possible because the memory card reader could not keep pace. Please use the high-speed
TF card, such as Class10 high-speed card.
If the loop recording is not working, it is also possible that gravity sensor is open, the files on memory card are all locked. Close the gravity
sensor setting, and the format the memory card.
Each time the camera settings cycle is not the same:
Check if motion detection function is on, because the camera motion detection state length of time, depending on the screen if there is no
movement.
Video recorded is unclear:
Please clean the lens before shooting the surface, keep the lens clean.
Bad video effect:
Camera and lightning conditions will affect the video quality, adjust the position of the dash cam for best result.
Images have streaks interference:
This is due to the wrong setting
“light frequency" produced under the fluorescent lights, the domestic flat rate "50HZ" when the machine
briefly press the "RESET" the reset button to restore restart.
