Elinchrom ELB 500 Head, User Manual

Page: 8 / 122

EN
7
User Manual
5. Press the ELB 500 Head locking
knob firmly down and turn the
reflector to the right until you hear
the snap-in noise.
6. Check if the reflector is well fitted.
7. Reconnect the flash cable to the
power pack and switch the unit on.
EXCHANGING REFLECTORS
1. Switch the ELB 500 power pack OFF and disconnect the
flash cable.
2. Mount the ELB 500 head to a tripod and lock with the
security screw.
3. Press the ELB 500 head locking knob firmly down and turn
the reflector to the left.
4. Now pull the reflector from the head.
FLASHTUBE REPLACEMENT
1. Switch the power pack off.
2. Disconnect the flash cable from the power pack.
3. Place the head horizontally on a rigid, clean and dry surface.
4. It will need to be held firmly whilst removing and replacing
the flashtube.
5. Allow the flashtube to cool down.
ALWAYS USE A PROTECTIVE GLOVE TO REMOVE THE
FLASHTUBE!
6. Remove the security spring from the flashtube and pull the
flashtube firmly out of the terminals.