QUICK INSTALLATION GUIDE
RiTa EasyGo– LPR System
Technical Documentation – All Rights Reserved
7
1.1.1
Install the EpCAM camera
The bracket can be adjusted in two different points.
Firstly, the bracket allows rotating the ball joint in a 35 degree spatial angle in any direction. Secondly, by
rotating the foot of the bracket, this angle can be extended with additional 20° according to the figure.
Steps of rotating the foot
1.
Remove the four screws (a) located at
the back of the foot. (Use size 4 Allen
key).
2.
Rotate the foot (b) by 180 degrees.
3.
Place the screws back into the holes
and screw them back on.
NOTE
: Do not over tighten the screws.
Attention:
Use appropriate screws for
installation according to the
mountable surface.
Damage to the product caused
during installation may void
the warranty.
1.1.2
Power Specifications
The camera may be powered at
12VDC
.
Please consider voltage drop on long cable lengths.
Input voltage: 12VDC
[nominal] (min.10V – max 15V) reverse polarity protected
Power
:
10W
Current
:
1A
(max 2,5A transients occur for a few µsec) – Over-current protection by fuse
Note
:
Connect the camera to the TCP/IP network before power on.
1.1.3
Environmental conditions
Maintain always clean the camera.
During cleaning operations please avoid the formation of scratches or other damages on the lens.
Do not use camera without the sunshield.
The minimal startup temperature of the camera is –20°C.
(a)
(a)
(a)
(a)
(b)
