8
required/needed, then provide an additional
hole/conduit.
e.
Install drywall around duct and conduit; then refinish
ceiling, leave enough clearance for easy installation of
chimney structure up to ceiling (see Installation step 6).
f.
Tape Template in place and fit 4 screws on mounting
holes, do not tighten but leave a space of 1/2“, remove
the template.
3.
Regulate chimney structure according dimension S (see
step 1) and fix all assembly parts with 4 screws to each
bracket (32 screws in total - 8 already in place , 24 to be
screwed in), check structure is well assembled.
4.
For non-vented (recirculating) installations ONLY:
Fix the deflector on the chimney structure.
5.
Note:
disregard this step if is intended to install a remote
ventilator.
Purchase and install the Integral ventilator (see
paragraph „Before installing the hood - Parts not
supplied“ for model reference).
6.
Raise chimney structure up to ceiling (keep 1/2“ conduit
and 8“ duct inside the proper passage), use the 4 screws
(see step 2/e and 2/f) to hang the hood.
Note: Chimeny structure front corresponds to side with
electronic box.
WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
Make final angular adjustment to structure at ceiling if
necessary then securely tighten 4 ceiling lag screws.
Fit two additional screws for definitive fixing.
7.
Connect ducting to transition. Seal with duct tape.
Do not use duct smaller than the transition.
For
Ductless - recirculating - installations
only:
provide and install a duct to connect hood transition to
deflector (the deflector is available as an extra kit).
