ELICA Horizonte, Use, Care And Installation Manual

Page: 11 / 56

11
12. Mount the lower support bracket with wood screws
(Supplied in mounting hardware kit) on locations
marked on template, then remove template.
13. Install duct cover support bracket to wall flush to ceiling
with drywall anchors supplied (the duct cover support
bracket should be installed about 1/8“ (3mm) away from
the ceiling).
14.
Hang hood with the 2 mounting hooks.
WARNING
Excessive Weight Hazard - Use two or more people to
move and install range hood. Failure to do so can result
in back or other injury.
15. Level the appliance, using a carpenters level across
bottom of hood with leveling screws in mounting hooks.
16. Secure hood with 2 screws on bottom.
17.
Connect ducting to transition. Seal with duct tape.
Do not use duct smaller than the transition.
18. Electrical connection
WARNING
Electrical Shock Hazard
Warning: Turn off power circuit at the service panel
before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE
MUST BE CONNECTED TO THE GROUNDING WIRE
IN YOUR HOME ELECTRICAL SYSTEM, AND IT
MUST UNDER NO CIRCUMSTANCES BE CUT OR
REMOVED.
Failure to do so can result in death or electrical
shock.
Remove the knockout and the Junction box cover and
install the conduit connector (cULus listed) in junction
box.
Run 3 wires; black, white and green ,according to the
National Electrical Code and local codes and
ordinances, in 1/2" conduit from service panel to
junction box.
Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
Close and secure junction box cover.