Carbon filter warning
After 160 hours of operation, LED L5 flashes.
When this warning appears, it means that the installed carbon filter needs to be replaced.
To reset the warning, press and hold key T1 for 3”.
In the event that both warnings appear at the same time, LED L5 will alternately indicate the alarms by remaining
on for 3” and then flashing 3 times.
This condition can be reset by performing the procedure described above twice.
The first time resets the grease filter warning, the second time resets the carbon filter warning.
In standard mode, the carbon filter warning is not active.
If the hood is used in the filter version, it is necessary to enable the carbon filter warning.
Carbon filter warning activation:
Switch the hood OFF and simultaneously press and hold keys T1 and T4 for 3”.
The LEDs L1 and L2 will flash for 5”.
Carbon filter warning deactivation:
Switch the hood OFF and simultaneously press and hold keys T1 and T4 for 3”.
The LED L1 will flash for 2”.
Temperature alarm
The hood is equipped with a temperature sensor that activates the motor at speed 3 if the temperature
in the control panel area is too high.
The alarm condition is indicated by the LEDs L1, L2 and L3 flashing in sequence.
This condition remains until the temperature drops below the alarm threshold.
It is possible to exit this mode by pressing T1 or T2.
Every 30”, the sensor checks the temperature in the control panel area.
OPERATION
A
B
C
D
A= ON/OFF light switch.
B= ON/OFF switch and select speed 1 (in case of little steam and smoke).
B+C= Select speed 2 (in case of medium amount of steam and smoke).
B+D= Select speed 3 (in case of a lot of steam and smoke).
END-OF-LIFE DISPOSAL
This device is marked in compliance with the European Directive 2012/19/EC - UK SI 2013 No.3113, Waste
Electrical and Electronic Equipment (WEEE). Make sure that this product is disposed of correctly. The user helps
prevent potential negative consequences for the environment and for health.
The symbol on the product or accompanying documentation indicates that this product should not be treated as
household waste but should be handed over at a suitable collection point for the recycling of electrical and electronic
equipment. Dispose of it in accordance with local regulations for waste disposal. For further information about the
treatment, recovery and recycling of this product, please contact your local authority, the collection service for household
waste or the shop from where the product was purchased.
RECOMMENDATIONS FOR USE
Recommendations for correct use in order to reduce the impact on the environment: When cooking begins, the device
should be turned on at minimum speed, and left on for a few minutes even after cooking is complete. Increase the speed
only if there is a large quantity of fumes and steam, using the Booster function only in extreme cases. To keep the odour
reduction system running efficiently, replace the carbon filter/s when necessary. To ensure the high performance of the
grease filter, clean it when necessary. To improve efficiency and minimise noise, use the maximum duct diameter
indicated in this manual.
10
Summary of Contents for FOLD BL/A/52
