Elgas DATCOM, Operating Instructions Manual

Page: 105 / 228

6
Operating the Device
103
6.9 Diagnostics
In the "Diagnostics" menu, the status of the corrector is displayed. The errors are indicated by the
prefix "E" and the identification number; similarly, the prefix "W" is used for warnings. For a
complete list of error and warning messages see paragraph 6.9.5.
i
Technical assistance in troubleshooting
If there are any problems with the operation of the device for any reason,
technical support personnel may be contacted. Contacts are available at
http://www.elgas.cz/kontakty.
To help you find a solution to the problem, we recommend providing as
much as possible information about your device and connections to related
devices nearby. Diagnostic and solving the problem would be easier, if you
send us a * .dt_all diagnostic file obtained from the device via a service SW
[42] or [43].
6.9.1 Current Status
This menu displays the current status of the device. Press the " right arrow " key to display all
current errors and warnings of the corrector one after another.
6.9.2 Summary Status
The summary status is used to monitor the occurrence of active error states (individual device
status bits) since the last summary status reset . This means also the statuses of the device
that have been removed by the operator, or have disappeared over time (typically, for example,
exceeding the pressure limit, etc.) are recorded in memory.
Fig. 53 Example of a summary status display
Basic status information is also displayed in the form of an icon (see Section 6.2) of the home
screen.
6.9.3 Summary Status Reset
After this option has been selected using the device keypad or via the "Summary Status Reset"
option from the "Setup-Diagnostics" menu of the PC utility SW, the summary status is initialized,
i.e. the current status is set according to the actual status. To enable initialization, the service