Elgar CW-P Series
SCPI Commands
:STORe?
Return the present EEPROM register
address that was read to set the present
setpoint/register values. CW shall read in
EEPROM address 0 at power-up.
:RECall <value>
Specify that CW shall read in the EEPROM
setpoint/registers from EEPROM location
<value>.
:ERRor?
Return the last Error logged by the GPIB/
RS-232 command processor. If there are no
errors, CW shall return as SPACE.
:EXTernal
External connectors sub-tree.
:CLOCk?
Return the present state of the Clock/Lock
connector interface circuit.
:CLOCk <description>
‘IN’ sets the Clock/Lock connector interface to
an input, ‘OUT’ makes the pin an output. See
Operation Manual
for the pinout of connectors.
:LOCK?
Returns 1 if the Phase Lock Loop is in the
acquired (locked) state.
:ANAIN <boolean>
‘1’ (ON) specifies that the CW amplifiers will
slew 0 through programmed value in relation
to a 0-5 volt control signal. See
Operation
Manual
for connector pinouts.
:ANAIN?
Returns ‘1’ if ANAIN is enabled.
:SERIALNO?
Returns the serial number.
:VER[S][ion]?
Return the code version of the FLASH
application presently active in the CW.
3.7 Master/Slave
Commands
:SLAVECONFIG <description>
Accepts A0A0,A0A1,A0A2,A0A3,A0A4,A0A5,
A0B0,A0B1,A0B2,A0B3,A0B4,A0B5,A0C0,
A0C1,A0C2,A0C3,A0C4,A0C5.
See
Operation Manual
for usage of these
master/slave configuration options.
:SLAVECONFIG?
Returns A0A0,A0A1,A0A2,A0A3,A0A4,A0A5,
A0B0,A0B1,A0B2,A0B3,A0B4,A0B5,A0C0,
A0C1,A0C2,A0C3,A0C4,A0C5.
:SLAVEADDR <value>
Accepts 0-5. See
Operation Manual
for usage.
:SLAVEADDR?
Returns 0-5.
:SLAVECHAN <value>
Accepts A,B,C. See
Operation Manual
for usage.
:SLAVECHAN?
Returns A-C.
Programming Manual
3-5
Summary of Contents for CW 1251P
Page 2: ......
