Bottom
Top
7
Align the T-bolts (G) with the holes in the upright assembly (A) support, carefully set the crossbar (B) down and adjust as
needed. Center the crossbar (B) left to right with the two upright assemblies (A). Repeat step with other crossbar (B).
2209 Kellen Gross Dr., Yankton SD 57078 • 877-878-9336
Install any t-slot compatible accessories. Then install all 4 crossbar end plugs (C) with set screws (D).
Start the channel guard at one end of crossbar, once started you should be able to press the channel guard down the channel
to the other end plug. Install channel guard (I) into the t-slot channel of both crossbars (B). Cut off any excess channel guard (I).
If no accessories are installed, the channel guard can reduce wind noise.
5
6
Use the provided 1/8” Allen key
to tighten set screws (D),
do
not overtighten.
Insert two T-bolts (G) into the bottom t-slot of each end of the crossbar (B). Repeat on the second crossbar.
4
Insert into
bottom t-slot
P/N 1118569 Rev. A Rev. 1-7-22
The serial number for the rack is located on
top of the crossbar. For future reference write
the serial number here.
________________________________
Bottom
Top
A
B
C
B
D
D
I
G
G
G
G
B
B
G
G
G
G
G
G
