Elettrobar River 282, Instruction Manual

Page: 7 / 110

INSTRUCTION MANUAL FOR DISHWASHERS
Page 7 of 10
GB
4.7 Emptying the machine
4.7.1 Machine without drain pump
¾ Turn off the machine. Disconnect the electricity and shut off the water.
¾
Remove the integral filter ( Fig.6 A ).
¾ Extract the overflow by pulling upwards (
Fig.7 B
), and wait for the tub to drain completely.
If necessary, extract the tub filter and clean (
Fig.7 C
).
4.7.2 Machine with drain pump
1. With the machine on (
Fig.4
), press the PROGRAMME SELECTION button (2)
until you see the message ‘ DRAIN’ .
2. Remove the integral filter (
Fig.6 A
).
3. Extract the overflow (
Fig.7 B
), close the door.
4. Press the START button (3) .
5.
The machine turns off at the end.
If necessary, extract the tub filter and clean (
Fig.7 C
).
4.7.3 Machines with partial draining: self-cleaning cycle and final draining
¾ Remove the basket from the machine.
¾ With the machine on (
Fig.4
), press the PROGRAMME SELECTION button (2)
until you see the message ‘DRAIN’ .
¾
Press the START button (3) .
¾
The machine will start a special wash sequence begins which makes it possible to clean and
drain the tub.
¾
The machine turns off at the end.
If necessary, extract the tub filter and clean
(
Fig.7 C
).
4.8 Resin regeneration
4.8.1 Machine with external water softener
In machines equipped with an external water softener, after a certain number of cycles, the display will
show the message
‘SOFT. MAINT.’. This indicates that the resins of the external softener must be
regenerated.
This signal remains even when the machine is off. To eliminate it, press and hold,
for at least five