22
EN
DD52R-E
Direct drive electronic position indicators
Models all rights reserved in accordance with the law.
Always mention the source when reproducing our drawings.
7.4 Direct programming of the absolute reference value (source) – of the
compensation value (offset) – of the reading after one revolution
The function of the keys combination allows direct access to the
programming of one of the following parameters, depending on the
value assigned to parameter
0 _ _ _ _ 0
.
It is possible to change the function of the keys combination
by setting the parameter
0 _ _ _ _ 0
The available options are:
-
P_OrG
: direct programming of the absolute reference value (OrG parameter)
-
P_StP
: direct programming of the reading after one revolution (StEP
parameter)
-
P_OFS
: direct programming of the compensation value (OFFS parameter)
-
OFF
: the keys combination
+
is not associated to any function in
the operating mode
For programming the parameters listed above see parameter
0 _ _ _ _ 0
of
paragraph 8.2.
7.5 Programming target position
The function of the keys combination allows, if the parameter
0 _ 0 _ _ _
has
been set on
tArGEt
, to program or to load one of the 32 target positions.
It is possible to change the function of the keys combination
by setting the parameter
0 _ 0 _ _ _
The available options are:
-
LOAd_t
: choose one of the 32 available target positions, then press
to
confirm
-
PrOG_t
: choose to program one of the 32 available target positions,
then press
to start programming
+
0 _ 0 _ _ _
0 _ _ _ _ 0
