16
12.
View program
Identical to programming item 8, but without modifying the values.
13.
Delete program
Press key "C” with a ball-point pen or similar object. The display
goes out. Also press the [DOWN] key.
Then release "C” key (full display appears for approx. 2 sec.).
After the full display has gone out, "clr” appears. Then likewise
release the [DOWN] key.
After the program has been deleted, reprogrammed light, temperatu-
re, wind and delay values and intermediate position/turning point are
deleted and the
basic program is active again (Menu 1).
The currently-measured light and wind value appear
14.
Programming intermediate position/
turning point
Note:
Programming an intermediate position or turning point is possible
only in manual mode (for explanation of operation/manual mode,
see Page 11).
Programming an intermediate position
The "intermediate position” function (only possible when straight)
allows the sunshade system to be positioned in an intermediate
position.
●
Press [Up] key and wait for "FTP” symbol
(see explanation on "FTP”, Page 17).
●
Press [Up] key and [Down] key
simultaneously
for at least 3 seconds.
●
Press [Down] key until the desired position is reached and then
also press the [Up] key in this position (this stores the position).
●
Release both keys.
Programming the turning point of a Venetian blind
The "turning point” function is for setting an automatic oblique angle
of the slats.
●
Press the [Up] key and wait for the "FTP” symbol (see explanation
of "FTP”, Page 17).
●
Press [Up] key and [Down] key simultaneously for at least
3 seconds.
●
Press [Down] key until the desired position is reached and then
also press the [Up] key several times in this position. This angles
the slats to the desired oblique angle
●
Release both keys (this stores the position).