elero MultiTel 2, Operating Instructions Manual

Page: 21 / 23

40 | EN Ⓒ elero GmbH
Ⓒ elero GmbH EN | 41
4.7 Changing the batteries
Important:
Replace batteries only with batteries of the
identical type.
1. Unscrew the device at the bottom with
a suitable tool and remove the cover.
2. Remove the batteries.
3. Insert the two new identical batteries
(AA, LR 06, Mignon) in the correct position
(note polarity).
4. Replace the cover and screw it to the device.
Fig. 5 Replacing batteries for the MultiTel 2
4.8 Cleaning and care of the device
• Use a soft, clean and dry cloth to clean the surface of
the device.
• Do not use cleaning agents and solvents.
• Keep the device dry.
• Do not use or store the device in dusty or dirty
environments.
• Do not store the device at high temperatures.
• Do not store the device at low temperatures.
• Do not try to open the device other than as described
in the operating instructions.
• Unauthorised modifications may damage device and
violate regulations applicable to radio devices.
• Do not drop the device, do not subject it to impact and
do not shake it. Rough treatment may damage sensitive
electronic circuits and mechanical components in the
device.
• Keep the device clear of magnets or magnetic fields.
5 EC Declaration of conformity
elero GmbH hereby declares that the device complies with
the basic prerequisites and the other relevant provisions of
the directives. The complete declaration of conformity can
be found in the download area of www.elero.com
6 Troubleshooting
Fault Cause Remedy
Drive does
not run; status
display does
not light up
Batteries are low
Batteries are
incorrectly
installed
Insert new
batteries
Insert batteries
correctly
Drive does
not run; status
display lights up
red or flashes
orange
1. The receiver
is outside of
sending range
2. Receiver out of
order or faulty
3. Receiver
not yet
programmed
1. Reduce
distance to
the receiver
2. Switch on or
exchange
receiver
3. Program
receiver
Desired drive
does not run
Incorrect group
or channel
selected
Select correct
group or channel
End positions
are approached
inaccurately
End positions
not yet set
Have the end
positions set
by a trained
specialist in
accordance
with the product
instructions