5. Operation
5-1. Preparation and Caution Before Measurement
1. The function switch should be set to the range to be measured
before operation.
If the function must be switched during a measurement, always
remove the test leads from the circuit being measured.
2. If the unit is used near noise-generating equipment, be aware
that the display may become unstable or indicate large errors.
3. Avoid using the unit in places with rapid temperature variations.
4. In order to prevent damage or injury to the unit, never fail to keep
the maximum tolerable voltage and current, especially for the
10A current range.
5. Carefully inspect the test leads.
If damaged, discard and
replace.
6. In order to avoid wrong range selection, be sure to check the
annunciator on the display.
5-2. Front Panel Description
1. Liquid Crystal Display
2. DC/AC Selector Switch
3. Data Hold Switch
4. Function/Rotary Switch
5. Capacitor Test Socket
6. TR h
FE
Test Socket
7. 10A Input Jack
8. mA Input Jack
9. Common Input Jack
10. V.
W
.Hz Input Jack
11. Holster
12. Peak Hold Switch
-8-
-9-
1
2
4
8
7
5
6
9
10
11
3
12
