1 7
Chapter 10
I N S T A L L A T I O N M A N U A L |
10�1�1
Decoration instructions
Step 1:
See
Figure 10.2
On
Figure 10.2
the empty burner can be seen with indications of the
pilot and thermocouple locations. Make sure these are not blocked by
decoation materials at all times.
Step 2:
See
Figure 10.3
en
Figure 10.4
Place the flowers on the burner dome. The flowers are palced using
a pattern repeated on each quarter of the dome, with some small
adjustments around the pilot. A single pattern consist of 30 flowers.
Three times flower 1 (large closed poppy), three times flower 2 (large
open poppy), three times flower 3 (large open rose), four times flower
4 (small ball), four times flower 5 (small closed rose), five times flower
6 (small open rose), four times flower 7 ( small closed poppy) and four
times flower 8 (tulip).
Figure 10.2 |
Locations pilot and thermocouple
8
8
8
8
1
2
2
2
1
1
3
3
3
Figure 10.3 |
Flower placement part 1
6
6
6
6
6
6
7
7
7
7
5
5
5
5
4
4
4
4
Figure 10.4 |
Flower placement part 2
Step 3:
See
Figure 10.5
Place the ceramic chips around the flowers, make sure to not block the
pilot or thermocouple.
10�2
CLEANING THE CERAMICS
Gently remove and clean the ceramics in the open air, using a soft brush
and a vacuum cleaner. Where necessary replace damaged components
only with genuine Element4 specified parts. Seal any scrap ceramics in
plastic bags and dispose at proper refuse sites. When using a vacuum
cleaner, it is recommended that one with a HEPA filtering system is used.
Re-fit the firebed arrangement, reseal the appliance and check the safe
operation of the appliance.
Figure 10.5 |
Chips placement