Operation
~ 5 ~
Turn on the audio source (TV or audio component) to which the
transmitter is
connected with. The blue signal LED on the transmitter
will light up.
1.
Select the channel 1 or 2 of the transmitter for best performance in
your location.
2.
Turn on the ON/OFF button on the speakers (the ON/OFF button on
the remote control unit cannot be used as a primary device to switch
on the speakers). Press the “AUTO TUNE” button to get the best
tuning reception in the speakers. When the button is pressed,
frequency tuning starts automatically and it stops when a signal is
detected. Tuning process can also be activated by pressing the “AUTO
TUNE” button on the remote control unit.
3.
Volume can be adjusted up by pressing “+” button or down by pressing
the button “-“ to the desired listening level, or you can press the “+”
button or “-“ button” on the remote control unit to adjust the volume
level.
4.
7 Meters
Note
Keep a distance of the speakers up to 7 meters apart from the
transmitter, and then press “AUTO TUNE” button for the best
reception.
a)
Whenever you find frequency jam, move your channel switch from one
channel to the other channel (there are two channels for selection) on
the transmitter, and then press the “AUTO-TUNE” button again.
b)
7 Meters
You should now be able to place the speakers freely from room to
room without disruption. Should there is any disruption (signal cuts off
or carries distortion), press the speaker's “AUTO TUNE” button to
maximize the best reception.
If you hear interference from other components, switch on the channel
control of transmitter, and then move the speakers to other free
location. You can re-adjust the tuning control by moving it either
channel 1 or 2 of the transmitter, then pressing “AUTO TUNE” button
for best reception.
When transmitting / receiving over long distances, the signal from the
system will become weaker.
5.
6. Switching Off
For protection of the transmitter and power saving, the transmitter
will cut off automatically if there is no/weak operation input signal
from audio source for 4 minutes.
In other words, if the signal comes back, the transmitter will work
again automatically.
a)
Press the ON/OFF button to turn off the speakers and the LED light
goes off, or simply press the ON/OFF button on the remote control
unit. If you use the remote control unit to turn off the speakers, the
speakers will be at stand-by mode for 5 minutes and the LED will be
changed from blue to yellow. You can switch on the speakers again
by using the remote control unit during the stand-by time. If there is
no signal from the remote control unit in 5 minutes, the speakers will
automatically power off.
b)
