9.3 Slave Mode
When a C1 is in slave mode is will duplicate all front panel and DMX commands that are sent to the master C1.
10. Engineering Mode
The Versa DRVIE C1 is equipped with an Engineering Mode for modifying low level paramters of the device.
Engineering Mode is most frequently used to adjust the output length of the data that the C1 generates from
1024 pixels (its default output length) to 2048 pixels.
To enter Enginering Mode:
1.
Goto Firmware (
F
#
)
menu and hit up
2.
Press the up and down buttons and hold for 5 seconds.
The three decimal points on the display with blink to indicate that you are in engineering mode.
The first menu option will appear on screen for about 5 seconds.
Hitting the mode button will go to the next menu option
To exit Engineering Mode press Mode and Up buttons simultaneously
10.1 Output
out
The first menu option is output setting, either 1 or 2.
A setting of 1 indicates that the C1’s output is set for 1024 pixels.
A setting of 2 indicates that the C1’s output is set for 2048 pixels.
Ensure that all buffer boxes, include all those include with a Vera TILE system are set to D1 mode, or 1024 pixels.
10.2 Balance Enable
ben
Not Implemented
10.3 Balance
bal
Not Implemented
10.4 Error Code
cod
Not Implemented
Revised July 18, 2006
Versa DRIVE C1
Page 14 of 16
User Manual