elektraLite Warm White Dazer, User Manual, Page: 5 / 14

7. Menus in the fixture.
Root Menu Sub Menu 1 Sub Menu 2
STAT (STATIC LOOK) W(HITE) 0-255
S(STROBE) 0-255
RUN DMX
STMT
DMX ASSIGN DMX CHANNEL 1-512
PERS (PERSONALITY) WD
WS
WS Id
ID ID 01 THROUGH 255 1-255
SET REST (RESET)
DV
DIM
KEY OFF
ON
8. Static Look.
The
Elektralite WW Dazer
can be set to a single static look quickly.
Use the Menu button to get to
STAT
.
Press Enter.
The next screen will read W.000. This is addressing the White leds.
Use the
↑ or ↓ to increase or decrease the output of the leds.
Numbers are expressed in DMX values so 0 is no output and 255 is highest output.
Press Enter to save the value.
The screen will automatically advance to the strobe. S.000 means the strobe is off
Use the
↑ or ↓ to increase or decrease the speed of the strobing or leave at S.000 if you want no strobe.
S.001 is the slowest and S.020 is the fastest strobing.
Press Enter to save the value. It will automatically bring you back to the output screen again.
Press the Menu button to exit out of
STAT
and back to the Root directory.
9. Run Mode.
Run
allows the fixture to operate in either DMX or STMT.
DMX Mode is where control of the fixture is via the industry standard DMX signal.
Further, when the DMX signal is lost, the fixture will maintain the last refresh of the DMX signal prior.
This way the facility is not plunged into total darkness.
In STMT Mode, when the DMX signal is lost, the fixture will go to whatever the output values are set at in the STATIC LOOK.
STMT mode is good in an emergency.
If the fixtures are in a venue that needs, in an emergency, the lights to come FULL ON, then engage STMT mode and
also make sure that the STATIC LOOK is set such that all leds are at 255. (See #8 Static Look above).
Using the Menu button in the root menu go to
RUN
.
Press Enter to get to DMX mode. Press Enter again to save the RUN mode as DMX.
A "ok" will appear and then the display will return to display
RUN
.
If the fixture is to be run in STMT mode, then when DMX mode appears on the screen instead of pressing enter use the ↑ or ↓
to get to STMT. Then press enter to save the STMT mode setting.