3. General Guidelines.
elektraLite UV
is a lighting fixture for professional use on stages, in clubs, theatres, churches etc.
elektraLite UV
should only be operated at between 120 to 240 volts and only indoors.
elektraLite UV
should not be operated 24/7 (24 hours a day; 7 days a week).
elektraLite UV
needs
operation breaks to ensure that it will work for a long time without problems. Please do not shake the
elektraLite UV
and avoid using brute force when installing or operating it.
Please read this below. It is important to understand and realize the following:-
The lens encapsulates each of the leds. This way the maximum output is attained. However this means
that, if the fixture is dropped or the front lens assembly is struck, then it is possible for leds to be crushed.
So please exercise care and attention. This is not a par64 that can be abused at will!
When choosing the location to install the
elektraLite UV
, please make sure that it is not exposed to
extreme heat, moisture or dust and never install it outdoors. Make sure that the fixture has a good amount
of free space around it for air flow. Do not install it in a confined space or have insulation around the
fixture. The minimum distance between the
elektraLite UV
and the illuminated surface must be more
than 3 feet.
Always mount the
elektraLite UV
with an appropriate safety cable.
Operate the
elektraLite UV
only when you are familiar with the features on the fixture. Do not permit
operation by persons not qualified.
All modifications to the
elektraLite UV will invalidate the warranty. There are absolutely no
exceptions.
If
elektraLite UV
is operated in any way different to the one described in this manual,
elektraLite UV
maybe damaged and the guarantee will be void.
4. Installation
Please ensure that the
elektraLite UV
is hung using the appropriate "C" clamp or half cheeseboro. A
safety chain or cable should also be used as a secondary point of holding the fixture in case the clamp
comes loose. Never hang the fixture without a safety chain or cable. Make sure the Gel frame (Gel
holder) is clipped into position correctly and cannot come loose.
If you are not qualified or have any doubts about hanging the
elektraLite UV
then do
NOT
hang it.
Do not clamp the safety cable to the U bracket or clamp. That is not a secondary safety point.
A secondary safety point is any point that will adequately hold the
elektraLite UV
if the "C" clamp or half
cheesboro fails. Then the safety cable would be the backup and stop the fixture from falling to the ground.
So do
NOT
fix the safety cable to the same place that the "C"clamp is attached.
