25
ENGLISH
A
Danger!
Repairs to electric tools must
be carried out by qualified electri-
cians only!
Electric tools in need of repair can be
sent to the service centre of your coun-
try. Refer to the spare parts list for the
address.
Please attach a description of the fault to
the electric tool.
•
Lower saw blade fully.
•
Dismount add-on parts (fence, slid-
ing carriage, table extension).
•
If possible use original carton for
shipping.
For special tasks the following accesso-
ries are available at your specialized
dealer – see back cover for illustrations:
A
Table Extension
For safe working of long stock.
B
Sliding Carriage
For convenient guiding of long
stock.
C
Suction Adapter
To connect a shop vacuum to the
dust collection attachment.
D
Care and Maintenance Spray
To remove resin residue and pre-
serve metal surfaces.
E
Saw blade HW 315 x 3.6 x 30
24 alternate bevel teeth
General purpose blade for rip and
cross cuts, also in particle board
(standard delivery).
F
Saw blade CV 315 x 1.8 x 30
56 multiple combination teeth
for solid wood and particle board.
G
Saw blade CV 315 x 1.8 x 30
80 neutral multiple teeth
For especially smooth cuts in solid
wood and particle board.
H
Saw blade TCT 315 x 2.8 x 30
48 universal alternate bevel teeth
For all woods and wood-derived
materials.
I
Roller Stand RS 420
J
Roller Stand RS 420 W
K
Roller Stand RS 420 G
The machine's packing can be 100%
recycled.
Worn out power tools and accessories
contain considerable amounts of valua-
ble raw and rubber materials, which can
be recycled.
These instructions are printed on paper
produced with elemental chlorine-free
bleaching process.
A
Danger!
Before carrying out any fault
service or maintenance work, always:
1.
switch machine OFF;
2.
unplug power cable;
3.
wait for saw blade to come to
standstill.
Check that all safety devices are
operational again after each fault
service.
Motor does not run
Undervoltage relay tripped by power fail-
ure:
−
switch on again.
No mains voltage
−
Check cables, plug, outlet and
mains fuse.
Motor overheated, e.g. by a blunt saw
blade or chip build-up in the chip case:
−
remove cause for overheating, wait
for a few minutes, then start saw
again.
Motor supply voltage too low:
−
use a shorter extension cable or
extension cable with larger lead
cross section
(
≥
1.5 mm
2
).
−
Have power supply checked by a
qualified electrician.
Loss of cutting performance
Saw blade blunt (possibly tempering
marks on blade body):
−
replace saw blade (see chapter
"Care and maintenance").
Saw dust build-up
No dust collector or dust collector of
insufficient capacity connected (see
“Dust collector” in chapter “Operation”):
−
connect dust collector, or
−
increase suction capacity.
Height adjustment mechanism of saw
blade working stiff
Spindle of height adjustment mechanism
gummy:
−
clean spindle and spray with Care
and Maintenance Spray (see chap-
ter "Care and maintenance").
11. Repairs
12. Transportation
13. Available accessories
14. Environmental Protection
15. Trouble Shooting