8
6
7
5
Take the second glass shelf (B) and slot it
over the bolt rods as shown, it should sit
comfortably on the middle tubes. Make sure
the smooth shiny side is facing downwards.
This will be facing upwards when the table is
turned the correct way up.
Take the 4 bottom tubes (E) and slide them
over the bolt rods and take the 4 foot pads
(G) and screw them to the ends of the bolt
rods as shown.
Take the 2 cable clamps (I) and attach them
to the cable panel (H) using the screws (J)
and nuts (K) using an appropriate screw
driver. Tighten the clamp screws to the
shelves, caution must be taken to attach
the clamps to the bottom 2 shelves with the
screws on the base as shown.
Flip your TV stand over so it rests on the
foot pads as shown. The stand is now ready
to use.