Page 13 of 20 M8015 issue 2.1
9. MAINTENANCE
9.1. General Information.
Unplug the unit from the mains voltage supply and allow it to cool before
undertaking any maintenance tasks.
Maintenance should only be carried out under the direction of the Responsible
Body, by a competent electrician. Failure to do so may result in damage to the
product and in extreme cases be a danger to the end user.
With proper care in operation this equipment has been designed to give many years
of reliable service. Contamination or general misuse will reduce the effective life of
this product and may cause a hazard.
Maintenance for the unit should include:
Periodic electrical safety testing (an annual test is recommended as the
minimum requirement).
Regular inspection for damage with particular attention to the mains lead and
plug.
Routine cleaning of the equipment should be undertaken using a clean cloth.
Hot water may be used to remove any solidified wax. Allow the equipment to
dry thoroughly before reconnecting the to the mains electricity supply.
DO NOT USE SOLVENTS FOR CLEANING ANY PART OF THIS
EQUIPMENT.
9.2. Internal Fuse Replacement.
The mains fuse holder is located at rear your product. Refer to Technical
Specification, ‘Fuse Rating’ for correct fuse type and rating. Turn your product off and
remove it from the mains supply. Open fuse draw and remove fuses. Fit replacement
fuses and close the draw.
