ELECTRIC BICYCLE METER S-LCD3 Product User Manual
- 35 -
○
C14 Power-assist tuning parameters
Enter into C14 parameter setting interface, C14 parameter bar flashes.
C14 parameter setting interface
C14 is the parameters of power-assist tuning with the default value of 2. The
power-assist is between1-4 gear, and it is invalid until P3 equals to 1. The setting range 1-3,
and press
(UP) button or
(DOWN) button for short to make selection.
C14 parameter definition table:
C14 Value
Assist strength of intelligent pedal motor
1
Weak assist strength of motor
2
General assist strength of motor
3
Stronger assist strength of motor
After finishing C14 parameter setting, hold
button
(SW)
shortly to save current
set values and enter C1 parameter setting interface again. Or hold
button
(SW)
long
for about 2 seconds to exit C parameter setting environment and return to the display 1.
○
Exit C Parameter Setting
Among the fourteen C parameter settings, when each parameter setting is completed,
if held
button (
SW
) long for about 2 seconds, all can exit the setting environment
and return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there’s no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.
Parameter Copy
Set parameters (include general project parameter, P parameter and C parameter) of
all S-LCD3 meter produced by our company according to requirements, and set the meter
