12
●
HDD Installation
3.1 Hard Disk Installation
○
1
Jumper Setup Master or Slave
To setup HDD as Master or Slave refer to explanation
(legend) on surface of Hard Disk.
Jumper is usually located between the data cable and the power
cable on rear side of the Disk.
If one Hard Disk installation , setup as Master
If two Hard Disk installation , setup second one as slave.
!! Make sure system is OFF and unplugged before installing
disk. If not, hard drive and system both can be damaged!!
d
Example of Samsung HDD Jumper Setup*
Refer to ‘General Pin Setting’ in ‘Jumper Pin Setting’ on
HDD Surface.
When one HDD installed, setup pin as Master and connect
Pin at the left end jumper.
When installing 2 or more HDD, one must be Master and the
other must be Slave (No pin).
When installing more than 2 HDD, use the CDRW ribbon
cable and setup the 3
rd
drive as Slave and leave the CDRW
as Master.
!!Please use only HDD rated higher than UDMA66!!
(Most newer drives are UDMA 133)
○
3
IDE Cable Connection to Main Board
Confirm the IDE cable inside of product
Blue colored connector attaches to the mainboard.
Master HDD connects to the end connector.
Slave HDD connects to the middle connector.
!! Warning!!
When adding a hard drive to an existing installation, ALL Hard Drives will be Formatted (Erased)
when the system is powered on. If you have data that must be saved, back it up BEFORE adding a
hard drive or it will be LOST.
