DIN RAIL TRAILING EDGE DIMMER – DMR.732 & DMR.733
User Manual.
(Ver.03)
ELECTRON S.A.
7 klm National Road Athens - Lamia, 68 Antiohias Str,
PROFESSIONAL LIGHTING SYSTEMS
N. Philadelphia, 143 41 Athens, Greece
[email protected], www.electron.gr
Tel. +30 210 2584240, Fax. +30 210 2584245
Select “DMR733” from the available devices for completing
the Bluetooth pairing between your device and DMR.733.
The device is ready for use. You can now control DMR.733
from your Bluetooth device!
With a single “tap” on the device you can switch it “on” or
“off”. You can also “tap & hold” the device and then by
sliding your finger to left and to the right you can adjust the
output of DMR.733 from 0% to 100% accordingly.
Casambi app offers a lot of options such as creating Scenes,
Selecting new name for the device, Dimming range etc. The
Scene editing can be adjusted from this page under the
section “Scenes”, while the other settings can be accessed
by double “tapping” on the device. These custom setting can
be seen in the following picture.
Set the minimum output level.
DMR.732 & DMR.733 has one regulator (trimmer) with which
you can adjust the minimum output level, avoiding any
unstable behavior of the lamps at low dimming areas. The
regulator is located at the center of the device and it is
marked as "MIN ADJUST".
Furthermore, when you connect to the output different types
of lamps and you notice that by rising the control signal of
the dimmer from 0%, each type of lamp starts to light up at
different percentage of the control signal. Then you can set
the minimum output percentage with the "MIN ADJUST", so
that in 0% of the control signal all types of lamps will have a
minimum brightness.
To set the minimum level of the output:
First, all controls (1/10V or Bluetooth) must go to 0%.
Then, adjust the regulator "MIN ADJUST" by observing
the lamps and stop the setting at the desired level.
Also, if you notice brightness instability of the lamps at the
level where they begin to light up, then adjust the "MIN
ADJUST" at a level slightly higher than the one that
instability occurred.
It is recommended at each dimmer to connect the same type
of lamps to get better adjustment of the brightness of the
space.
Be aware that the minimum output level cannot be more
than 50%.
"MIN ADJUST" can also be used for testing the load
connections (mainly for DMR.733) before we pair the dimmer
to a Bluetooth device or connecting it with 1/10V and Push
button controller.
Finally, if "MIN ADJUST" setting is not needed, it can be
disabled by setting the regulator at 0%.
