29
Sending MIDI DIN Sync
1. Press [PLAY] to start clock with a 2 millisecond delay to allow devices to
react.
2. Press [STOP] and [STOP] again will prepare sync and hold clock until
[PLAY] is pressed or a midi start message is sent (no delay)
9.2 CV Configuration
2 dual (AB)(CD) ¼” , Control Voltage / Gate outputs and a CV Track for control of the output
are available on the A4.
CV / Gate Overview
Typically CV/Gate signals were used on traditional analogue synthesizers as a means to
communicate with each other. MIDI later superseded CV, however CV/Gate functions have
again become popular to allow communication with older and modular equipment and where
improved resolution is required.
Although the implementation of CV can vary, it typically uses a mechanism of Voltage per
Octave (1V per Octave) and Hertz per Volt as controls. The A4 Supports both as well as a
linear control voltage output.
Gate is a pulsed output to trigger note events. Two types are typically used, Voltage Trigger (V-
Trig) and Short Circuit trigger (S-Trig)
NOTE: It is important to use the correctly wired connections and cables when using
CV/MIDI for the selected configuration to ensure proper operation and to protect the
integrity of any hardware equipment
.
Summary of Contents for ANALOG 4
Page 3: ......