12
3
Brush Roll
The brush roll turns as it sweeps and combs the carpet nap.
Remove hair and threads from the brush roll so it continues
brushing the carpet. To maintain the most efficient cleaning,
the bristles must touch the carpet. To test the bristle length,
hold a ruler against the underneath side of the cleaner. If the
bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt
The brush roll belt turns the brush roll to agitate, sweep, and
comb the carpet nap. Check the belt regularly to be sure it is
in good condition. Replace the belt if it stretches, cracks or
loses tension. Cut away any hair or threads wound around the
brush roll or the belt pulley because the buildup could cause
the belt to rotate unevenly.
How To Replace Brush Roll Belt
NOTE: Turn off the switch and
unplug the electrical
cord before replacing
belt. Belt pulleys can
become hot during
normal use. To prevent
injury, avoid touching
the motor pulley when
checking the belt.
1. Lower handle to floor
to change belt.
2. Loosen, but do not
remove, two screws
to release hood. Lift
hood to remove.
Motor
Pulley
Belt
Brush
Roll
4
2
2
1
5
5. Place new belt around motor pulley.
.
7
6
Left side view
6. Place belt around brush roll pulley.
7. Align left end cap with square in base.
Push end cap into place; see left side view.
8
8. Pull right side of brush roll to stretch belt.
Secure right end cap into base.
9
9. Rotate brush roll to seat belt.
10. Replace the hood. Make sure hood front is
behind furniture guard. Hood should seat onto
self-locating screw tabs.
11. Tighten screws.
Use GENUINE Electrolux replacement belt.
3. Lift left end of brush roll.
4. Remove and discard belt.
