and then by 1 hour up to a maximum of 20
hours by means of this button.
The selected delay time value will appear on
the display for about 3 seconds, then the du-
ration of the programme will appear again.
You must select this option after you have set
the programme and before you press the
button
7
.
You can modify or cancel the delay time at
any moment, before you press the button
7
.
The door will be locked throughout the delay
time. If you wish to add laundry in the ma-
chine during the delay time, press the button
7
to set the machine to pause. When the
Door symbol disappears, the door can be
opened. Add the laundry, close the door and
press the button
7
again.
Selecting the delayed start.
• Select the programme and the required
options.
• Select the delay start.
• Press button
7
: the appliance starts its
hourly countdown. The programme will
start after the selected delay has expired.
Cancelling the delayed start
• Set the washing machine to PAUSE by
pressing the button
7
;
• Press button
8
until the symbol ’ is dis-
played;
• Press the button
7
again to start the pro-
gramme.
Important!
The selected delay can be
changed only after selecting the washing
programme again.
The Delay Start can not be selected with
Drain programme.
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out. Before you
make any change, you must pause the
washing machine by pressing the button
7
.
Changing a running programme is possible
only by resetting it
. Turn the programme
selector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the
7
button again. The washing
water in the tub will not emptied out.
Interrupting a programme
Press the button
7
to interrupt a programme
which is running, the corresponding light
starts blinking. Press the button again to re-
start the programme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running. Now you can se-
lect a new programme.
Opening the door after the programme
has started
When the machine is working and through-
out the delay time the door is locked. If, for
any reason, you wish to open the door, set
firstly the machine to pause by pressing the
button
7
.
• If the DOOR symbol disappears, the door
can be opened;
• If the DOOR symbol doesn’t go off, it
means that the machine is already heating
or that the water level is too high. In this
case the door cannot be opened;
• If you cannot open the door but you need
to open it, you have to switch the machine
off by turning the selector dial to
. After
a few minutes the door can be opened
(pay attention to the water level and
temperature!)
;
After closing the door, it is necessary to se-
lect the programme again and to press but-
ton
7
.
At the end of the programme
The machine stops automatically, the pilot
light of button
7
pilot light goes off, a blinking
appears on the display and the acoustic
signal sounds for some minutes.
If you have chosen a programme or an option
that ends with water in the tub,
follow the
below instruction to empty the water
out:
• turn the programme selector dial to
• select the DRAINING or SPINNING pro-
gramme
• reduce the spin speed if needed, by
means of the relevant button
• press the button
7
• when the programme has finished the dis-
play shows a blinking . On the display
the DOOR symbol disappears and the
door can be opened.
Turn the programme selector dial to
to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty.
10
electrolux