Warning!
When a unit is no longer being
used:
• Pull the plug out of the socket.
• Cut off the cable and plug and dispose of them.
• Dispose of the door catch. This prevents chil-
dren from trapping themselves inside and en-
dangering their lives.
Installation
Transporting the appliance
Important!
Only tip the appliance on its left side
to transport (see illustration), if it cannot be
transported in an upright position.
Warning!
If the appliance was not
transported in an upright position, leave it to
stand for 12 hours before connecting it to the
electricity supply and using it for the first time, so
that the oil can flow back to the compressor.
Otherwise the compressor could be damaged.
Appliance positioning
• It is recommended that, for your convenience,
the machine is positioned close to your washing
machine.
• The tumble dryer must be installed in a clean
place, where dirt does not build up.
• Air must be able to circulate freely all round the
appliance. Do not obstruct the front ventilation
grille or the air intake grilles at the back of the
machine.
• To keep vibration and noise to a minimum when
the dryer is in use, it should be placed on a firm,
level surface.
• Once in its permanent operating position, check
that the dryer is absolutely level with the aid of a
spirit level. If it is not, raise or lower the feet until
it is.
• The feet must never be removed. Do not restrict
the floor clearance through deeppile carpets,
strips of wood or similar. This might cause heat
built-up which would interfere with the operation
of the appliance.
Important!
• The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The appli-
ance must therefore not be installed on floors
which are not resistant to high temperatures.
• When operating the tumble dryer, the room tem-
perature must not be lower than +5°C and high-
er than +35°C, as it may affect the performance
of the appliance.
• Should the appliance be moved, it must be
transported vertically.
• The appliance must not be installed behind the
lockable door, a sliding door a door with a hinge
on the opposite side to that of the appliance in
such a way that a full opening of the dryer is re-
stricted.
Removing transport safety packaging
Caution!
Before use all parts of the transport packaging
must be removed.
1. Open loading door
2. Pull off adhesive strips from inside machine on
top of drum.
3. Remove foil hose and polystyrene padding
from the machine.
Electrical connection
Details on mains voltage, type of current and the
fuses required should be taken from the type plate.
The type plate is fitted near the loading aperture
(see “Product description” chapter).
Warning!
The manufacturer declines any
responsibility for damage or injury through
failure to comply with the above safety
precautions.
Should the appliance power supply cable need to
be replaced, this must be carried out by our Serv-
ice Center.
Warning!
The power supply cable must be
accessible after installing the machine.
Door reversal
Warning!
Before changing the door stop,
disconnect the mains plug.
electrolux
47
Summary of Contents for TW SL EEV
Page 59: ...electrolux 59 ...
