Electrolux Side by Side Refrigerator, Service Manual

Page: 121 / 137

114
Section G - Ice & Water Dispenser
With the board removed, remove the 3 screws from
the dispenser housing and pull the dispenser forward.
(See Figure 17)
Remove water line from dispenser housing by pulling
straight out. (See Figure 18)
With the water line removed, the upper part of the
dispenser is free of the freezer door panel. The main
housing is part of the door panel, and is not removable.
(See Figure 19)
The ice door and actuator switches, as well as the return
springs, can be serviced with the control module
removed. (See Figure 20)
The closer can be replaced by removing 3 screws and lifting closer from housing.
The door is held in place with a shaft at the top. The spring that holds the door
closed and sealed against the housing is over the shaft and can be replaced by
using a small punch and removing the shaft. (See Figure21)
The door closer is mounted on the side of the housing (See Figure 21) and
connected to the door arm with a gear wheel to slow the closing of the door. (See
Figure 22) This allows enough time for the ice to clear the chute.
The door will take approximately 20 seconds to close after the glass is removed
from the actuator.
Figure 17
Remove
screws
Pull housing
forward
Figure 18
Remove
water line
Main housing for
dispenser is part
of the outer door
panel.
Figure 19 Figure 20
Ice Door
Door Closer
Return Springs
Actuator
Switches
Figure 20