9
Be sure lights are cool before cleaning the hood.
To Clean Filters
The metal grease filters will last forever.
They are made of anodized aluminum
It is recommended that the filters be washed at least once a month; they can be
washed by hand or in the dishwasher.
Drain water through edge holes and let each filter dry thoroughly before replacing
it.
To Remove The Metal Grease Filters
Disconnect the hood from electricity.
Push clips towards the rear and pull the filters downward.
Disengage each filter from a side and remove it
To Replace The Metal Grease Filters
Reverse procedure.
To Clean Hood Surface
For general care, wipe the outside of the stainless steel, white, black or glass
hood with sudsy water or household cleaners such as Fantastic® or Formula
409
®
, rinse well and dry with clean soft cloth to avoid water marks.
Wipe and dry brushed stainless steel in the same direction as the grain.
Do not use abrasive products.
To remove finger prints and give added shine use spray cleaners such as
Stainless Steel Magic
®
and Shimmer
®
.
Hood Cleaning
NOTE:
Turn blower and lights off. Make sure the lights are cool.
If new lights
do not operate be sure lights are inserted correctly before calling service.
Remove the light cover using a little flat screwdriver or similar tool as a lever.
Remove the damaged light and replace with a new 12 Volt, 20 Watt (maximum)
halogen light made for a G-4 base. Follow package directions and do not touch
new light with bare hands.
Reinstall the light cover (snap into position).
Lights replacement
Figure 9
Figure 9
Light
Light cover
Figure 8
Turn off electric power to hood before
removing light cover.
