- 8 -
TSE-N 05.00 A. B.
599 50 78 52EN
Code
E
and/or LED
END
and/or
SHORT
is/are flashing:
-
Maximum refilling time of 45 sec or maximum allowed number of 3 refillings exceeded.
Possible errors: inlet hose allows too less water,
sieve clogged
water pressure too low, water tap or
regenerating dosage (inlet bow) calcified
appliance is losing water
Code
H
and/or LED
END
and/or
RINSE
is/are flashing:
-
Maximum heating time of 45 min exceeded without reaching the working temperature.
Possible errors: heating defective
heating relais without function
80°C thermostat switches too early or
irregularly
Code
L
and/or LED
END
and/or
ECO
is/are flashing:
-
Short circuit or interruption with the NTC temperature sensor.
Possible errors: NTC temperature sensor faulty
connection dropped off
Code
E2
(appears only on the 8-keys electronic for 2 sec after actuating the main switch):
-
Appliance will lose saved values in case of a power failure or when pressing the mains
switch.
Error:
E2PROM in electronic is faulty.
This error has no influence on the function of the dishwasher.
Note:
Both old error messages
P
and
U
are no longer considered in these controls. P (short circuit level
switch) was newly integrated in message
C
.
U
(pump/cond interruption or short circuit) is dropped as a power monitoring is not possible because of
the phase-angle control.
