42
BEFORE YOU CALL
The oven control display shows
"SPr" and self-clean is not
working.
The cooktop should not be used during a self-clean cycle. On some models, turning
on any cooktop surface burner will cause the clean cycle to cancel. If the clean cycle
is canceled, the oven control display will show “SPr" for 5 seconds. The oven door will
remain locked until the oven has cooled down below cleaning temperature. If the
oven is below cleaning temperature, the user can start another clean cycle immedi-
ately. If the oven is in cleaning temperature range, another self-clean cycle can be set
once the door unlocks (up to 4 hours).
Other Problems
Appliance is not level.
Be sure the floor is level, strong, and stable enough to adequately support the range.
If the floor is sagging or sloping, contact a carpenter to correct the situation.
Poor installation. Place the oven rack in the center of the oven. Place a level on the
oven rack. Adjust the leveling legs at the base of the appliance until the rack is level.
Kitchen cabinet alignment may make range appear not level. Be sure cabinets are
square and have sufficient room for appliance clearance.
Cannot move appliance easily.
Appliance must be accessible for
service.
Cabinets not square or are built in too tightly. Contact the builder or installer to make
the appliance accessible.
Carpet interferes with appliance. Provide sufficient space so the appliance can be
lifted over carpet. Installation over carpet is not advised. See the installation instruc-
tions for guidelines specific to your appliance.
Oven light does not work.
Be sure the oven light is secure in the socket. See
Problem
Cause / Solution
Summary of Contents for Frigidaire FGGF3047TF
Page 43: ...43 BEFORE YOU CALL ...