Electrolux FDR251RJR0, Service Manual

Page: 13 / 35

12
Replace Selector Switch
1. Disconnect dishwasher from the power supply .
2. Remove control panel. (See Remove Control
Panel.)
3. Remove switch mounting screws.
4. Remove plastic shield from switch. Reinstall onto
new switch.
5. Transfer wires to new switch.
6. Reinstall new switch in reverse order.
Replace Door Latch Assembly
1. Disconnect dishwasher from electrical supply.
2. Remove control panel. (See Remove Control
Panel.)
3. Remove wires from door switches.
4. Remove two screws mounting latch to inner door
panel.
5. Slightly pull latch away from top and lift up to clear
location tab on bottom of latch from mounting hole
on inner door panel.
Warning : Be sure the wires are installed on door
switch properly. Make sure both black wires are
on one switch as well as both white wires are on
the second switch.
Replace the Detergent and Rinse Aid
Dispenser
1. Disconnect dishwasher from electrical supply.
2. Remove outer door panel. ( See Remove Outer
Panel)
3. Remove two wires from wax motor actuator.
4. Remove six screws holding dispenser.
Note:
Gasket for dispenser only comes with
dispenser.
Replace Thermostat
1. Disconnect dishwasher from electrical supply.
2. Remove outer door panel. (See Remove Outer
Panel.)
3. Remove screw holding retainer over thermostat.
4. Remove wires from thermostat.
NOTE:
If Selector Switch is a rocker switch,
squeeze locks on ends of switch to remove it from
the control panel.
Screws to mount
dispenser
Remove Access Panel
1. Disconnect dishwasher from electrical supply.
2. Open dishwasher door and remove two screws
from top of access panel.
3. Close door; remove two screws, one on either side
of panel.
4. Pull access panel out and up to remove.
5. To reinstall, reverse order.
Replace Float Switch and Mounting
Bracket
1. Disconnect dishwasher from electrical supply.
2. Remove access panel .(See Remove Access
Panel above.)
3. Remove electrical wires from switch.
4. Carefully spread switch retainers and slide switch
out of bracket.
Caution : When reinstalling door latch, be sure
location tab is in hole in the inner door panel. If the
location tab is not in hole properly, the door
switches may not close properly. See figure below.