13
Prior to using for the first time
Setting the amount of rinse aid required
3
Only change the amount dispensed, if smears, milky spots (reduce the amount)
or dried on water spots (increase the amount) can be seen on glasses and dishes.
(See section “If dishwashing results are not satisfactory”.) The dosage can be set
from 16. The dosage is preset to “4” in the factory.
1.
Open the dishwasher door.
2.
Press the release button on the rinse aid
compartment.
3.
Open the cover.
4.
Set the dosage level.
5.
Press the lid shut until it clicks into place.
6.
If rinse aid has leaked out, wipe it away
with a cloth.
Activating rinse aid inflow when 3in1 function is selected
3
If the 3in1 function is not selected, the rinse aid inflow is always activated.
If the 3in1 function is selected due to the use of 3in1 detergent, the rinse aid in
flow is deactivated. If the dishes then do not dry sufficiently, you should reacti
vate the rinse aid inflow (see also section “Using 3in1 detergents”).
1.
Press the ON/OFF button.
3
If the only LED indicator illuminated is one that belongs to a programme button,
this means that this dishwashing cycle has been activated. The dishwashing cy
cle must be deselected:
Press function buttons
1
and
2
simultaneously for approx. 2 seconds.
The LED indicators of all the programme buttons that can be selected light up.
2.
Press function buttons
1
and
2
simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
3.
Press function button
2
.
The LED indicator for function button
2
will flash.
The multidisplay will indicate the current setting:
0d
Rinse aid inflow deactivated when 3in1 on (factory setting)
1d
Rinse aid inflow activated when 3in1 on
