Fitting under a counter (kitchen worktop or sink)
By removing the machine's worktop, you can install it under a close fitting sink unit or a
pre-existing top, providing the dimensions of the recess correspond to those shown in the
picture.
Proceed as follows:
1. Remove the machine's worktop by un
-
screwing the two rear retaining screws,
pull the worktop from the back of the ma
-
chine and slide out the front slots, lifting
the worktop.
2. Insert the machine after adjusting the lev
-
elling with the adjustable feet.
When inserting the machine, ensure that the water inlet and drain hoses are not kinked or
squashed.
During all operations that involve accessibility to internal components the dishwasher has
to be unplugged.
Be sure that once the appliance has been installed, it is easily accessible for the service
engineer in the event that a repair is required.
If the dishwasher is later used as a free-standing appliance, the original worktop must be
re-mounted.
The plinth on free-standing appliances is not adjustable.
Levelling
Good levelling is essential for correct closure and sealing of the door. When the appliance
is correctly levelled, the door will not catch on either side of the cabinet. If the door does
not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.
Water connection
Water supply connections
This appliance can be connected to either a hot (max. 60°) or cold water supply.
Water connection
25
Summary of Contents for FAVORIT 50673
Page 1: ...FAVORIT 50673 User manual Dishwasher ...
Page 29: ...29 ...
Page 30: ...30 ...
Page 31: ...31 ...
