1. Open the porthole and extract the inlet
hose.
2. Connect the hose with the angled con-
nection to the machine. Do not place the
inlet hose downwards. Angle the hose to
the left or right depending on the position
of your water tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Water-stop device
The inlet hose is provided with a water stop
device, which protects against damage
45°
35°
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window
«A»
. Should this occur, turn the
water tap off and refer to your Service Centre
to replace the hose.
A
Water drainage
The end of the drain hose can be positioned
in three ways.
•
Hooked over the edge of a sink
using
the plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the ma-
chine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
•
In a sink drain pipe branch.
This branch
must be above the trap so that the bend is
at least 60 cm above the ground.
•
Directly into a drain pipe
at a height of
not less than 60 cm and not more than 90
cm. The end of the drain hose must always
be ventilated, i.e. the inside diameter of the
electrolux
27
Summary of Contents for EWX14550W
Page 1: ...user manual Washer dryer EWX 14550 W ...
Page 31: ...electrolux 31 ...
